download free wiring diagram

This is design circuit for DC coupled current monitor that is eliminates the previous circuit’s trim but pulls more current from the APD bias supply. A1 floats powered by the APD bias rail. This is the figure of the circuit.

The 15V zener diode and current source Q2 ensure A1 never is exposed to destructive voltages. The 1kW current shunt’s voltage drop sets A1’s positive input potential. A1 balances its inputs by feedback controlling its negative input via Q1. As such, Q1’s source voltage equals A1’s positive input voltage and its drain current sets the voltage across its source resistor. Q1’s drain current produces a voltage drop across the ground referred 1k resistor identical to the drop across the 1kW current shunt and, hence, APD current. This relationship holds across the 20V to 90V APD bias voltage range. The 5.6V zener assures A1’s inputs are always within their common mode operating range and the 10M resistor maintains adequate zener current when APD current is at very low levels.

Two output options are shown. A2, a chopper stabilized amplifier, provides an analog output. Its output is able to swing to (and below) zero because its V– pin is supplied with a negative voltage. This potential is generated by using A2’s internal clock to activate a charge pump which, in turn, biases A2’s V– pin. A second output option substitutes an A-to-D converter, providing a serial format digital output. No V– supply is required, as the LTC2400 A-to-D will convert inputs to (and slightly below) zero volts. [Schematic’s circuit source: Linear Technology Notes].

Related Posts : circuit, coupled, current, dc, monitor